H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 5 MSDP Configuration Commands
5-13
Examples
# Add the descriptive text “Router CstmrA” for the router with the IP address of
125.10.7.6 to indicate that this router is Customer A.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] peer 125.10.7.6 description Router CstmrA
5.1.12 peer mesh-group
Syntax
peer peer-address mesh-group name
undo peer peer-address mesh-group
View
MSDP view
Parameters
peer-address: MSDP peer address.
name: Mesh group name, a case-sensitive string of 1 to 32 characters.
Description
Use the peer mesh-group command to configure an MSDP peer as a mesh group
member.
Use the undo peer mesh-group command to remove an MSDP peer as a mesh group
member.
By default, an MSDP peer does not belong to any mesh group.
Examples
# Configure the MSDP peer with the IP address of 125.10.7.6 as a member of the mesh
group “Grp1”.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] peer 125.10.7.6 mesh-group Grp1
5.1.13 peer minimum-ttl
Syntax
peer peer-address minimum-ttl ttl-value
undo peer peer-address minimum-ttl