H3C S7500E Series Command Manual

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-5
View
AUX interface view
Parameters
5: Five data bits.
6: Six data bits.
7: Seven data bits.
8: Eight data bits.
Description
Use the databits command to set the databits for the user interface.
Use the undo databits command to revert to the default data bits.
The default data bits is 8.
 Note:
H3C S7500E Series Ethernet Switches only support data bits 7 and 8. To establish the
connection again, you need to modify the configuration of the termination emulation
utility running on your PC accordingly.
Examples
# Set the data bits to 7.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] databits 7
1.1.5 display telnet client configuration
Syntax
display telnet client configuration
View
Any view
Parameter
None

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English