Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands
1-10
Parameters
agg-id: Link aggregation group ID.
manual: Creates a manual link aggregation group.
static: Creates a static LACP link aggregation group.
Description
Use the link-aggregation group mode command to create a link aggregation group.
Use the undo link-aggregation group command to remove a link aggregation group.
If the group is functioning as a service loop group, this can result in the removal of the
service loop group.
An aggregation group currently being referenced by other modules cannot be removed.
Related commands: display link-aggregation summary.
Examples
# Create manual link aggregation group 22.
<Sysname> system-view
[Sysname] link-aggregation group 22 mode manual
1.1.10 link-aggregation group service-type
Syntax
link-aggregation group agg-id service-type tunnel
undo link-aggregation group agg-id service-type
View
System view
Parameters
agg-id: Link aggregation group ID.
tunnel: Sets the service type to tunnel.
Description
Use the link-aggregation group service-type command to configure a manual
aggregation group as a service loop group that is of specific type.
Use the undo link-aggregation group service-type command to change a service
loop group back to a common manual aggregation group.
To Next Page
Loading...
Need help?
General
