Command Manual – DHCP
H3C S7500E Series Ethernet Switches
Chapter 2 DHCP Relay Agent Configuration
Commands
2-14
No. Group IP
1 1.1.1.1
2 1.1.1.2
Table 2-4 Description on fields of the display dhcp relay server-group command
Field Description
No. Sequence number
Group IP IP address in the server group
2.1.18 display dhcp relay statistics
Syntax
display dhcp relay statistics [ server-group { group-id | all } ]
View
Any view
Parameters
group-id: Specifies a server group number in the range of 0 to 19 about which to display
DHCP packet statistics.
all: Specifies all server groups about which to display DHCP packet statistics.
Information for each group will be displayed.
Description
Use the display dhcp relay statistics command to display DHCP packet statistics
related to a specified or all DHCP server groups.
Note that if no parameter (server-group and all) is specified, all DHCP packet statistics
on the relay agent will be displayed.
Examples
# Display all DHCP packet statistics on the relay agent.
<Sysname> display dhcp relay statistics
Bad packets received: 0
DHCP packets received from clients: 0
DHCPDISCOVER packets received: 0
DHCPREQUEST packets received: 0
DHCPINFORM packets received: 0
DHCPRELEASE packets received: 0
DHCPDECLINE packets received: 0
BOOTPREQUEST packets received: 0
To Next Page
Loading...
Need help?
General
