Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-17
Field Description
Peer IP Address(es) Interface IP address of the neighbor
Uptime
Time that elapsed since the neighbor relationship
was formed.
Adj Protocol Adjacency protocol
4.1.14 display isis route
Syntax
display isis route [ ipv4 ] [ [ level-1 | level-2 ] | verbose ] * [ process-id ]
View
Any view
Parameters
ipv4: Displays IS-IS IPv4 routing information (the default).
verbose: Displays IS-IS detailed IPv4 routing information.
process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.
level-1: Displays Level-1 IS-IS routes.
level-2: Displays Level-2 IS-IS routes.
 Note:
If no level is specified, then both Level-1 and Level-2 (Level-1-2) routing information will
be displayed.
Description
Use the display isis route command to display IS-IS IPv4 routing information.
Examples
# Display IS-IS IPv4 routing information
<Sysname> display isis route 1
Route information for ISIS(1)
-----------------------------
ISIS(1) IPv4 Level-1 Forwarding Table
-------------------------------------
To Next Page
Loading...
Need help?
General
