Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Commands
1-30
1.1.30 storm-constrain interval
Syntax
storm-constrain interval seconds
undo storm-constrain interval
View
System view
Parameters
Seconds: Interval for generating traffic statistics, in the range 1 to 300 (in seconds).
Description
Use the storm-constrain interval command to set the interval for generating traffic
statistics.
Use the undo storm-constrain interval command to restore the default.
By default, the interval for generating traffic statistics is 10 seconds.
 Note:
z The interval set by the storm-constrain interval command is specifically for the
storm constrain function. It is different form that set by the flow-interval command.
z For network stability consideration, configure the interval for generating traffic
statistics to a value that is not shorter than the default.
Examples
# Set the interval for generating traffic statistics to 60 seconds.
<Sysname> system-view
[Sysname] storm-constrain interval 60
1.1.31 unicast-suppression
Syntax
unicast-suppression { ratio | pps max-pps }
undo unicast-suppression
View
Ethernet port view, port group view
To Next Page
Loading...
Need help?
General
