Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Chapter 1 AAA/RADIUS/HWTACACS
Configuration Commands
1-33
Description
Use the data-flow-format command to specify the unit for data flows or packets to be
sent to a RADIUS server.
Use the undo data-flow-format command to restore the default.
By default, the unit for data flows is byte and that for data packets is one-packet.
Related commands: display radius scheme.
Examples
# Define RADIUS scheme radius1 to send data flows and packets destined for the
RADIUS server in kilobytes and kilo-packets.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] data-flow-format data kilo-byte packet kilo-packet
1.2.2 display radius scheme
Syntax
display radius scheme [ radius-scheme-name ] [ slot slot-number ]
View
Any view
Parameters
radius-scheme-name: RADIUS scheme name.
slot slot-number: Specifies the slot where the interface card is inserted.
Description
Use the display radius scheme command to display the configuration information of a
specified RADIUS scheme or all RADIUS schemes.
Related commands: radius scheme.
Examples
# Display the configurations of all RADIUS schemes.
<Sysname> display radius scheme
------------------------------------------------------------------
SchemeName = radius1
Index=0 Type=extended
Primary Auth IP = 1.1.1.1 Port = 1812 State = active
Primary Acct IP = 1.1.1.1 Port = 1813 State = active
Second Auth IP = 0.0.0.0 Port = 1812 State = block