To Next Page

To Previous Page

Command Manual – IPv4 Routing

H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands

4-13

Description

Use the display isis lsdb command to display IS-IS link state database.

Examples

# Display Level-1 LSDB information.

<Sysname> dis isis lsdb level-1

Database information for ISIS(1)

--------------------------------

Level-1 Link State Database

LSPID Seq Num Checksum Holdtime Length ATT/P/OL

--------------------------------------------------------------------------

bbbb.cccc.dddd.00-00* 0x0000001d 0x165 820 36 1/0/0

*-Self LSP, +-Self LSP(Extended), ATT-Attached, P-Partition, OL-Overload

Table 4-4 Description on the fields of the display isis lsdb command

Field Description

LSPID Link state packet ID

Seq Num LSP sequence number

Checksum LSP checksum

Holdtime LSP holdtime

Length LSP length

ATT/P/OL

Attach bit (ATT)

Partition bit (P)

Overload bit (OL)

4.1.11 display isis mesh-group

Syntax

display isis mesh-group [ process-id ]

View

Any view

Parameters

process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series