H3C S7500E Series

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Chapter 2 Port Isolation Configuration
Commands
2-1
Chapter 2 Port Isolation Configuration Commands
2.1 Port Isolation Configuration Commands
2.1.1 display port-isolate group
Syntax
display port-isolate group
View
Any view
Parameters
None
Description
Use the display port-isolate group command to display the information about the
system default isolation group group1.
Examples
# Display the information about the system default isolation group.
<Sysname> display port-isolate group
Port-isolate group information:
Uplink port support: NO
Group ID: 2
Ethernet2/0/4 Ethernet2/0/5
Table 2-1 Description on the fields of the display port-isolate group command
Field Description
Port-isolate group information
Display information of a port-isolation
group
Uplink port support Whether support uplink port
Group ID Isolation group number
Ethernet2/0/4 Ethernet2/0/5
Ordinary ports (non-uplink ports) in a
isolation group