H3C S7500E Series

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-17
1.1.10 display ipv6 relay-tunnel
Syntax
display ipv6 relay-tunnel
View
Any view
Parameters
None
Description
Use the display ipv6 relay-tunnel command to display IPv6 recursive tunnel
information.
Examples
# Display IPv6 recursive tunnel information.
<Sysname> display ipv6 relay-tunnel
Total Number of relay-tunnel is: 1.
Dest/Mask: 192::0/64
Related instance id(always 0): 0(1)
Table 1-8 display ipv6 relay-tunnel command output description
Field Description
Total Number of Relay-tunnel Total number of recursive tunnels
Dest/Mask Destination address/mask of the recursive tunnel
Related instance id(always 0)
IPv6 supports public networks only. Therefore, the
instance ID can be 0 only.
The number in the parentheses after the instance
ID indicates the number of routes that have used
the recursive route in the routing table.
1.1.11 display ipv6 routing-table
Syntax
display ipv6 routing-table
View
Any view