H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-23
Table 3-17 Description on the fields of the display ospfv3 topology command
Field Description
Type Type of node
ID(If-Index) Router ID
Bits Flag bit
Metric Cost value
Next-Hop Next hop
Interface Outbound interface
3.1.17 display ospfv3 vlink
Syntax
display ospfv3 [ process-id ] vlink
View
Any view
Parameters
process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.
Description
Use the display ospfv3 vlink command to display OSPFv3 virtual link information. If
no process is specified, virtual link information of all OSPFv3 processes is displayed.
Examples
# Display OSPFv3 virtual link information.
<Sysname> display ospfv3 vlink
Virtual Link VLINK1 to router 1.1.1.1 is up
Transit area :0.0.0.1 via interface Vlan-interface100, instance ID: 0
Local address: 2000:1::1
Remote address: 2001:1:1::1
Transmit Delay is 1 sec, State: P-To-P,
Timer intervals configured, Hello: 10, Dead: 40, Wait: 40, Retransmit:
5
Hello due in 00:00:02
Adjacency state :Full

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English