Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 5 MSDP Configuration Commands
5-7
Table 5-3 Description on the fields of the display msdp sa-cache command
Field Description
(Source, Group) (S, G) entry: (source address, group address)
Origin RP Address of the RP that generated the (S, G) entry
Pro
Type of protocol from which the AS number is
originated. “?” indicates that the system was unable to
obtain the protocol type.
AS
AS number of the origin RP. “?” indicates that the
system was unable to obtain the AS number.
Uptime
Length of time for which the cached (S, G) entry has
been existing, in hours:minutes:seconds
Expires
Length of time in which the cached (S, G) entry will
expire, in hours:minutes:seconds
5.1.5 display msdp sa-count
Syntax
display msdp sa-count [ as-number ]
View
Any view
Parameters
as-number: AS number, in the range of 1 to 65535.
Description
Use the display msdp sa-count command to view the number of SA messages in the
MSDP cache.
This command gives the corresponding output only after the cache-sa-enable
command is executed.
Related commands: cache-sa-enable.
Examples
# View the number of SA messages in the MSDP cache.
<Sysname> display msdp sa-count
Number of cached Source-Active entries, counted by Peer
Peer's Address Number of SA
10.10.10.10 5
To Next Page
Loading...
Need help?
General
