H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 5 MSDP Configuration Commands
5-8
Number of source and group, counted by AS
AS Number of source Number of group
? 3 3
Total 5 Source-Active entries
Table 5-4 Description on the fields of the display msdp sa-count command
Field Description
Number of cached Source-Active
entries, counted by Peer
Number of SA messages per peer
Peer's Address MSDP peer addresses
Number of SA Number of SA messages from this peer
AS
Number of the AS where the MSDP peer is
located. “?” indicates that the system was
unable to obtain the AS number.
Number of source Number of multicast sources from this AS
Number of group Number of multicast groups from this AS
5.1.6 encap-data-enable
Syntax
encap-data-enable
undo encap-data-enable
View
MSDP view
Parameters
None
Description
Use the encap-data-enable command to enable register message encapsulation in SA
messages.
Use the undo encap-data-enable command to disable register message
encapsulation in SA messages.
By default, an SA message contains only an (S, G) entry. No register message is
encapsulated in an SA message.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English