H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 5 MSDP Configuration Commands
5-6
View
Any view
Parameters
group-address: Multicast group address in the (S, G) entry, in the range of 224.0.1.0 to
239.255.255.255.
source-address: Multicast source address in the (S, G) entry.
as-number: AS number, in the range of 1 to 65535.
Description
Use the display msdp sa-cache command to view the information of (S, G) entries in
the MSDP cache.
Note that:
z This command gives the corresponding output only after the cache-sa-enable
command is executed.
z If you do not provide a source address, this command will display the information
of all sources in the specified multicast group.
z If you do not provide a group address and a source address, this command will
display the information of all cached entries.
z If you do not provide an AS number, this command will display the information
related to all ASs.
Related commands: cache-sa-enable.
Examples
# View the information of (S, G) entries in the MSDP cache.
<Sysname> display msdp sa-cache
MSDP Total Source-Active Cache - 5 entries
(Source, Group) Origin RP Pro AS Uptime Expires
(10.10.1.2, 225.1.1.1) 10.10.10.10 BGP 100 00:00:10 00:05:50
(10.10.1.3, 225.1.1.1) 10.10.10.10 BGP 100 00:00:11 00:05:49
(10.10.1.2, 225.1.1.2) 10.10.10.10 BGP 100 00:00:11 00:05:49
(10.10.2.1, 225.1.1.2) 10.10.10.10 BGP 100 00:00:11 00:05:49
(10.10.1.2, 225.1.2.2) 10.10.10.10 BGP 100 00:00:11 00:05:49
MSDP matched 5 entries