Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands
1-5
Description
Use the display link-aggregation summary command to display a summary for all
link aggregation groups.
You may find that information about the remote system for a manual link aggregation
group is either replaced by none or not displayed at all. This is normal because this type
of aggregation group has no knowledge of its partner.
Examples
# Display the link aggregation group summary.
<Sysname> display link-aggregation summary
Aggregation Group Type: S -- Static, M -- Manual
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor ID: 0x8000, 0000-fcff-ff04
AL AL Partner ID Select Unselect Share Master
ID Type Ports Ports Type Port
-------------------------------------------------------------------
10 M none 1 0 NonS Ethernet2/0/2
20 S 0x8000,0000-fcff-ff01 1 0 NonS Ethernet2/0/3
Table 1-3 Description on the fields of the display link-aggregation summary
command
Field Description
Aggregation Group Type
Aggregation group type.
z S: static LACP aggregation
z M: manual aggregation
Loadsharing Type Load sharing type
Actor ID Local system ID
AL ID Link aggregation group ID
AL Type Link aggregation type
Partner ID Remote system ID
Select Ports Number of selected ports
Unselect Ports Number of unselected ports
Share Type Load sharing type
Master Port Master port
To Next Page
Loading...
Need help?
General
