Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-19
Examples
# Send messages to all user interfaces.
<Sysname> send all
Enter message, end with CTRL+Z or Enter; abort with CTRL+C:
hello^Z
Send message? [Y/N]y
<Sysname>
***
***
***Message from vty0 to vty0
***
hello
<Sysname>
1.1.21 service-type
Syntax
service-type { ftp | lan-access | { ssh | telnet | terminal }* [ level level ] }
undo service-type { ftp | lan-access | { ssh | telnet | terminal }* }
View
Local user view
Parameters
ftp: Specifies the users to be of FTP type.
lan-access: Specifies the users to be of LAN-access type, which normally means
Ethernet users, such as 802.1x users.
ssh: Specifies the users to be of SSH type.
telnet: Specifies the users to be of Telnet type.
terminal: Makes terminal services available to users logging in through the Console
port.
level level: Specifies the user level for Telnet users, Terminal users, or SSH users. The
level argument ranges from 0 to 3 and defaults to 0.
Description
Use the service-type command to specify the login type and the corresponding
available command level.
Use the undo service-type command to cancel login type configuration.
To Next Page
Loading...
Need help?
General
