Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-18
Parameters
screen-length: Number of lines the screen can contain. This argument ranges from 0 to
512 and defaults to 24.
Description
Use the screen-length command to set the number of lines the terminal screen can
contain.
Use the undo screen-length command to revert to the default number of lines.
You can use the screen-length 0 command to disable the function to display
information in pages.
Examples
# Set the number of lines the terminal screen can contain to 20.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] screen-length 20
1.1.20 send
Syntax
send { all | number | type number }
View
User view
Parameters
all: Specifies to send messages to all user interfaces.
type: User interface type.
number: Absolute user interface index or relative user interface index.
z Relative user interface index: If you provide the type argument, the number
argument indicates the user interface index of the type. When the type is AUX,
number is 0; when the type is VTY, number ranges from 0 to 4.
z Absolute user interface index: If you do not provide the type argument, the number
argument indicates the absolute user interface index, and ranges from 0 to 5.
Description
Use the send command to send messages to a specified user interface or all user
interfaces.
To Next Page
Loading...
Need help?
General
