To Next Page

To Previous Page

Command Manual – Link Aggregation

H3C S7500E Series Ethernet Switches Chapter 1 Link Aggregation Configuration Commands

1-2

Description

Use the display link-aggregation interface command to display detailed information

about link aggregation for the specified port or ports.

You may find that information about the remote system is replaced by 0 and no

statistics about LACPDUs are provided for manual link aggregation groups. This is

normal because this type of aggregation group has no knowledge of its partner and

does not use LACP PDUs for maintaining link aggregation.

Examples

# Display detailed information about link aggregation for port Ethernet 2/0/1 in a manual

aggregation group.

<Sysname> display link-aggregation interface ethernet 2/0/1

Flags: A -- LACP_Activity, B -- LACP_timeout, C -- Aggregation,

D -- Synchronization, E -- Collecting, F -- Distributing,

G -- Defaulted, H -- Expired

Ethernet2/0/1:

Selected AggID: 1

Local:

Port-Priority: 32768, Oper key: 1, Flag: {}

Remote:

System ID: 0x0, 0000-0000-0000

Port Number: 0, Port-Priority: 0, Oper-key: 0, Flag: {}

# Display detailed information about link aggregation for port Ethernet 2/0/2 in a static

aggregation group.

<Sysname> display link-aggregation interface ethernet 2/0/2

Flags: A -- LACP_Activity, B -- LACP_timeout, C -- Aggregation,

D -- Synchronization, E -- Collecting, F -- Distributing,

G -- Defaulted, H -- Expired

Ethernet2/0/2:

Selected AggID: 20

Local:

Port-Priority: 32768, Oper key: 2, Flag: {ACDEF}

Remote:

System ID: 0x8000, 000e-84a6-fb00

Port Number: 2, Port-Priority: 32768 , Oper-key: 10, Flag: {ACDEF}

Received LACP Packets: 8 packet(s), Illegal: 0 packet(s)

Sent LACP Packets: 9 packet(s)

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series