H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-46
[Sysname] acl number 3000
[Sysname-acl-adv-3000] rule permit ip source 10.10.0.0 0.0.255.255
destination 225.1.0.0 0.0.255.255
[Sysname-acl-adv-3000] quit
[Sysname] pim
[Sysname-pim] register-policy 3000
4.1.52 register-suppression-timeout
Syntax
register-suppression-timeout interval
undo register-suppression-timeout
View
PIM view
Parameters
interval: Register suppression timeout in seconds, in the range of 1 to 3,600.
Description
Use the register-suppression-timeout command to configure the register
suppression timeout time.
Use the undo register-suppression-timeout command to restore the system default.
By default, the register suppression timeout time is 60 seconds.
Related commands: probe-interval, register-policy.
Examples
# Set the register suppression timeout time to 70 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] register-suppression-timeout 70
4.1.53 register-whole-checksum
Syntax
register-whole-checksum
undo register-whole-checksum
View
PIM view