H3C S7500E Series

Command Manual – Multicast
H3C S7500E Series Ethernet Switches Chapter 4 PIM Configuration Commands
4-48
4.1.55 source-lifetime
Syntax
source-lifetime interval
undo source-lifetime
View
PIM view
Parameters
interval: Multicast source lifetime in seconds, with an effective range of 1 to 65,535.
Description
Use the source-lifetime command to configure the multicast source lifetime.
Use the undo source-lifetime command to restore the system default.
By default, the lifetime of a multicast source is 210 seconds.
Related commands: state-refresh-interval.
Examples
# Set the multicast source lifetime to 200 seconds.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] source-lifetime 200
4.1.56 source-policy
Syntax
source-policy acl-number
undo source-policy
View
PIM view
Parameters
acl-number: Basic or advanced ACL number, in the range of 2000 to 3999.
Description
Use the source-policy command to configure a multicast data filter.
Use the undo source-policy command to remove the configured multicast data filter.
By default, no multicast data filter is configured.