H3C S7500E Series Command Manual

Command Manual – PoE
H3C S7500E Series Ethernet Switches Chapter 1 PoE Configuration Commands
1-19
View
Any view
Parameters
None
Description
Use the display poe-power status command to display the status information of the
PoE power.
Examples
# Display the status information of the PoE power.
<Sysname>display poe-power status
Switch Number : 1
Switch 1 State : AC Switch High Voltage
DC Output State : Under Limit
DC Output Voltage : 56.00 V
DC Output Current : 15.00 A
Module Number : 2
Output AC Current A Alarm : Normal
Output AC Current B Alarm : Under Limit
Output AC Current C Alarm : Lack Phase
Module 1:
Volt Phrase AB Alarm : Above Limit
Volt Phrase BC Alarm : Fuse Broken
Volt Phrase CA Alarm : Switch Off
Module 2:
Volt Phrase AB Alarm : Above Limit
Volt Phrase BC Alarm : Fuse Broken
Volt Phrase CA Alarm : Switch Off
Table 1-12 Description on the fields of the display poe-power status command
Field Description
Switch Number Number of power switches
Switch x State State of a power switch
DC Output State DC output state
DC Output Voltage DC output voltage
DC Output Current DC output current
Module Number Number of modules that a PSU contains

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English