H3C S7500E Series

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-2
To verify the configuration, do the following:
# Exit the terminal session on the aux port, and enter <s> at the prompt of “Please
press ENTER”. You will see the terminal session being started.
[Sysname-ui-aux0] return
<Sysname> quit
**************************************************************************
* Copyright (c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights reserved.*
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
**************************************************************************
User interface aux0 is available.
Please press ENTER.
<Sysname>
%Apr 28 04:33:11:611 2005 Sysname SHELL/5/LOGIN: Console login from aux0
1.1.2 authentication-mode
Syntax
authentication-mode { none | password | scheme [ command-authorization ] }
View
User interface view
Parameters
none: Does not authenticate users.
password: Authenticates users using the local password.
scheme: Authenticates users locally or remotely using usernames and passwords.
command-authorization: Performs command authorization on TACACS
authentication server.
Description
Use the authentication-mode command to specify the authentication mode.
z If you specify the password keyword to authenticate users using the local
password, remember to set the local password using the set authentication
password { cipher | simple } password command.
z If you specify the scheme keyword to authenticate users locally or remotely using
usernames and passwords, the actual authentication mode depends on other