To Next Page

To Previous Page

Command Manual – Port Correlation Configuration

H3C S7500E Series Ethernet Switches

Chapter 1 Ethernet Port Configuration

Commands

1-23

 Note:

z If a suppression ratio is set in global configuration mode or in port configuration

mode, the suppression ratio which first satisfies the condition takes effect.

z If you set different suppression ratios in Ethernet port view or port-group view for

multiple times, the latest configuration takes effect.

z Do not use the multicast-suppression command along with the storm-constrain

command. Otherwise, the multicast storm suppression ratio configured may get

invalid.

Examples

# Allow multicast traffic equivalent to 20% of the total transmission capability to pass

through Ethernet 2/0/1 and suppress the excessive multicast packets.

<Sysname> system-view

[Sysname] interface ethernet 2/0/1

[Sysname-Ethernet2/0/1] multicast-suppression 20

# On all the ports of the manual port group named group1, allow multicast traffic

equivalent to 20% of the total transmission capability of each port to pass and suppress

excessive multicast packets.

<Sysname> system-view

[Sysname] port-group manual group1

[Sysname-port-group manual group1] group-member ethernet 2/0/1

[Sysname-port-group manual group1] group-member ethernet 2/0/2

[Sysname-port-group manual group1] multicast-suppression 20

1.1.22 port-group

Syntax

port-group { manual port-group-name | aggregation agg-id }

undo port-group manual port-group-name

View

System view

Parameters

manual port-group-name: Name of a specified manual port group, a string of 1 to 32

characters.

H3C S7500E Series Command Manual

Other manuals for H3C S7500E Series