Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-29
Examples
# Configure the maximum number of equal-cost routes for load-balancing as 2.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] maximum load-balancing 2
3.1.23 ospfv3
Syntax
ospfv3 [ process-id ]
undo ospfv3 [ process-id ]
View
System view
Parameters
process-id: OSPFv3 process ID, ranging from 1 to 65535. The process ID defaults to 1.
Description
Use the ospfv3 command to enable an OSPFv3 process and enter OSPFv3 view.
Use the undo ospfv3 command to disable an OSPFv3 process.
The system runs no OSPFv3 process by default.
Related commands: router-id.
 Note:
An OSPFv3 process can run normally only when Router ID is configured in OSPFv3
view. Otherwise, you can find the process, but which cannot generate any LSA.
Examples
# Enable the OSPFv3 process with process ID as 120 and configure the Router ID as
1.1.1.1.
<Sysname> system-view
[Sysname] ospfv3 120
[Sysname-ospfv3-120] router-id 1.1.1.1
To Next Page
Loading...
Need help?
General
