H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 3 IPv6 OSPFv3 Configuration Commands
3-28
undo log-peer-change
View
OSPFv3 view
Parameters
None
Description
Use the log-peer-change command to enable the logging on neighbor state changes.
Use the undo maximum load-balancing command to disable the logging.
With this feature enabled, information about neighbor state changes of the current
OSPFv3 process will display on the configuration terminal.
Examples
# Disable the logging on neighbor state changes of OSPFv3 process 100.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] undo log-peer-change
3.1.22 maximum load-balancing
Syntax
maximum load-balancing maximum
undo maximum load-balancing
View
OSPFv3 view
Parameters
maximum: Maximum number of equal-cost routes for load-balancing. The argument
being set to 1 means no load balancing is available. Its value is in the range 1 to 4.
Description
Use the maximum load-balancing command to configure the maximum number of
equal-cost routes for load-balancing.
Use the undo maximum load-balancing command to restore the default.
By default, the maximum number of equal-cost routes for load-balancing in OSPFv3 is
4.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English