H3C S7500E Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 3 Device Management Commands
3-15
Field Remarks
Laser bias current fault Laser bias current fault
Laser temperature fault Laser temperature fault
Laser output power fault Laser output power fault
TX fault TX fault
PMA/PMD receiver local fault PMA/PMD receiver local fault
PCS receive local fault PCS receive local fault
PHY XS receive local fault PHY XS receive local fault
TX bias high TX bias current is high.
TX bias low TX bias current is low.
TX power high TX power is high.
TX power low TX power is low.
Temp high Temperature is high.
Temp low Temperature is low.
Transceiver info I/O error Transceiver information read and write error
Transceiver info checksum error Transceiver information checksum error
Transceiver type and port
configuration mismatch
Transceiver type does not match port
configuration.
Transceiver type not supported by
port hardware
Transceiver type is not supported on the port.
 Note:
For pluggable transceivers supported by S7500E series Ethernet switches, refer to
H3C S7500E Series Ethernet Switches Installation Manual.
Examples
# Display the alarm information of the transceiver on interface GigabitEthernet 2/0/1.
<Sysname> display transceiver alarm interface gigabitethernet 2/0/1
GigabitEthernet2/0/1 transceiver current alarm information:
TX fault

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English