H3C S7500E Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches Chapter 3 Device Management Commands
3-14
Field Remarks
RX power low RX power is low.
TX not ready TX is not ready.
TX fault TX fault
TX CDR loss of lock TX clock cannot be recovered.
TX bias high TX bias current is high.
TX bias low TX bias current is low.
TX power high TX power is high.
TX power low TX power is low.
Module not ready Module is not ready.
APD supply fault APD (Avalanche Photo Diode) supply fault
TEC fault TEC (Thermoelectric Cooler) fault
Wavelength unlocked
Wavelength of optical signal exceeds the
manufacturer’s tolerance.
Temp high Temperature is high.
Temp low Temperature is low.
Voltage high Voltage is high.
Voltage low Voltage is low.
Transceiver info I/O error Transceiver information read and write error
Transceiver info checksum error Transceiver information checksum error
Transceiver type and port
configuration mismatch
Transceiver type does not match port
configuration.
Transceiver type not supported by
port hardware
Transceiver type is not supported on the port.
XENPAK
WIS local fault WIS (WAN Interface Sublayer) local fault
Receive optical power fault Receive optical power fault
PMA/PMD receiver local fault
PMA/PMD (Physical Medium
Attachment/Physical Medium Dependent)
receiver local fault
PCS receive local fault
PCS (Physical Coding Sublayer) receiver local
fault
PHY XS receive local fault
PHY XS (PHY Extended Sublayer) receive
local fault
RX power high RX power is high.
RX power low RX power is low.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English