H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-15
Auth Type : NONE
Track IF : Vlan-interface200 Pri Reduced : 10
Virtual IP : FE80::1
Virtual MAC : 0000-5e00-0201
Master IP : FE80::20F:E2FF:FE49:8060
Table 1-3 Description on the fields of the display vrrp ipv6 command
Field Description
Run Method Current VRRP running mode, real MAC or virtual MAC
Virtual IP Ping Whether you can ping the virtual IPv6 address
Interface Interface to which the standby group belongs
VRID Number of the standby group
Adver. Timer VRRP advertisement interval in centiseconds
Admin Status Administrative state: UP or DOWN
State
Status of the switch in the standby group, master, backup,
or initialize
Config Pri Configured priority
Run Pri Running priority
Preempt Mode Preemption mode
Delay Time
Preemption delay, not displayed when the device works in
non-preemption mode.
Auth Type Authentication type
Track IF
The interface to be tracked. It is displayed only after the
execution of the vrrp ipv6 vrid track command.
Pri Reduced
The priority value that is reduced when the interface being
tracked is down.
It is displayed only after the execution of the vrrp ipv6
vrid track command.
Virtual IP Virtual IPv6 addresses of the standby group
Virtual MAC
Virtual MAC address corresponding to the virtual IPv6
address of the standby group. It is displayed only when the
switch is in the state of master.
Master IP
Primary IPv6 address of the interface to which the switch
in the state of master belongs

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English