H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches Chapter 1 VRRP Configuration Commands
1-2
<Sysname> display vrrp
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
The total number of the virtual routers: 1
Interface VRID State Run Adver. Auth Virtual
Pri Time Type IP
---------------------------------------------------------------------
Vlan100 1 Master 100 1 NONE 10.10.10.2
# Display detailed information about all standby groups on the device.
<Sysname> display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Virtual IP Ping : Enable
Interface : Vlan-interface100
VRID : 1 Adver. Timer : 1
Admin Status : UP State : Master
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Track IF : Vlan-interface200 Pri Reduced : 10
Virtual IP : 10.10.10.2
Virtual MAC : 0000-5e00-0101
Master IP : 10.10.10.1
Table 1-1 Description on the fields of the display vrrp command
Field Description
Run Method Current VRRP running mode, real MAC or virtual MAC
Virtual IP Ping
Whether you can ping the virtual IP address of the standby
group
Interface Interface to which the standby group belongs
VRID Number of the standby group
Adver. Timer VRRP advertisement interval
Admin Status Administrative state: UP or DOWN
State
Status of the switch in the standby group, master, backup, or
initialize
Config Pri Configured priority
Run Pri Running priority
Preempt Mode Preemption mode

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English