H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 4 IS-IS Configuration Commands
4-45
Parameters
None
Description
Use the is-snmp-traps enable command to enable the SNMP Trap function of IS-IS.
Use the undo is-snmp-traps command to disable this function.
SNMP Trap is enabled by default.
Examples
# Enable SNMP Trap.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] is-snmp-traps enable
4.1.43 log-peer-change
Syntax
log-peer-change
undo log-peer-change
View
IS-IS view
Parameters
None
Description
Use the log-peer-change command to enable logging on IS-IS adjacency state
changes.
Use the undo log-peer-change command to disable the logging.
The feature is enabled by default.
After the feature is enabled, information about IS-IS adjacency state changes is sent to
the configuration terminal.
Examples
# Enable logging on the IS-IS adjacency state changes.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] log-peer-change