H3C S7500E Series

Command Manual – IP Routing Overview
H3C S7500E Series Ethernet Switches Chapter 1 Routing Overview Commands
1-9
192.168.0.0/24 Direct 0 0 192.168.0.136 Vlan1
192.168.0.136/32 Direct 0 0 127.0.0.1 InLoop0
For detailed description of the above output, see Table 1-4.
# Display detailed information about both active and inactive routes permitted by basic
ACL 2000.
<Sysname> display ip routing-table acl 2000 verbose
Routes Matched by Access list : 2000
Summary Count : 2
Destination: 192.168.0.0/24
Protocol: Direct Process ID: 0
Preference: 0 Cost: 0
NextHop: 192.168.0.136 Interface: Vlan-interface1
RelyNextHop: 0.0.0.0 Neighbor : 0.0.0.0
Tunnel ID: 0x0 Label: NULL
State: Active Adv Age: 1d04h26m42s
Tag: 0
Destination: 192.168.0.136/32
Protocol: Direct Process ID: 0
Preference: 0 Cost: 0
NextHop: 127.0.0.1 Interface: InLoopBack0
RelyNextHop: 0.0.0.0 Neighbor : 0.0.0.0
Tunnel ID: 0x0 Label: NULL
State: Active NoAdv Age: 1d04h26m42s
Tag: 0
For the description of the command output above, seeTable 1-5.
1.1.5 display ip routing-table ip-address
Syntax
display ip routing-table ip-address [ mask-length | mask ] [ longer-match ]
[ verbose ]
display ip routing-table ip-address1 { mask-length | mask } ip-address2 { mask-length
| mask } [ verbose ]
View
Any view
Parameters
ip-address: Destination IP address, in dotted decimal format.