H3C S7500E Series

Command Manual – ACL
H3C S7500E Series Ethernet Switches Chapter 1 ACL Configuration Commands
1-17
Table 1-6 Parameters for advanced IPv4 ACL rules
Parameters Function Description
icmp-type
{ icmp-type
icmp-code |
icmp-message }
Specifies the ICMP
message type and
code.
The icmp-type argument ranges from 0
to 255.
The icmp-code argument ranges from 0
to 255.
The icmp-message argument specifies a
message name. For available ICMP
messages, see
Table 1-7..
The following table provides the ICMP messages that you can specify in advanced IPv4
ACL rules.
Table 1-7 ICMP messages and their codes
ICMP message Type Code
echo 8 0
echo-reply 0 0
fragmentneed-DFset 3 4
host-redirect 5 1
host-tos-redirect 5 3
host-unreachable 3 1
information-reply 16 0
information-request 15 0
net-redirect 5 0
net-tos-redirect 5 2
net-unreachable 3 0
parameter-problem 12 0
port-unreachable 3 3
protocol-unreachable 3 2
reassembly-timeout 11 1
source-quench 4 0
source-route-failed 3 5
timestamp-reply 14 0
timestamp-request 13 0
ttl-exceeded 11 0