EasyManuals Logo

H3C S7500E Series Command Manual

H3C S7500E Series
1565 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1126 background imageLoading...
Page #1126 background image
Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-7
View
Traffic behavior view
Parameters
cir committed-information-rate: Specifies the committed information rate (CIR) in kbps.
The committed-information-rate argument ranges from 64 to 10000000 and must be a
multiple of 64.
cbs committed-burst-size: Specifies the committed burst size (CBS) in bytes. The
committed-burst-size argument ranges from 4000 to 16000000, the default is 4000.
ebs excess-burst-size: Specifies excess burst size (EBS) in bytes. The
excess-burst-size argument ranges from 0 to 16000000, the default is 4000.
pir peak-information-rate: Specifies the peak information rate (PIR) in kbps. The
peak-information-rate argument ranges from 64 to 10000000 and must be a multiple of
64.
green action: Specifies the action to be conducted for the traffic conforming to CIR. The
action argument can be:
z discard: Drops the packets.
z pass: Forwards the packets.
z remark-dscp-pass new-dscp: Marks the packets with a new DSCP precedence
and forwards them to their destinations. The new-dscp argument is in the range 0
to 63.
By default, packets conforming to CIR are forwarded.
red action: Specifies the action to be conducted for the traffic conforms to neither CIR
nor PIR. The action argument can be:
z discard: Drops the packets.
z pass: Forwards the packets.
z remark-dscp-pass new-dscp: Marks the packets with a new DSCP precedence
and forwards them to their destinations. The new-dscp argument is in the range 0
to 63.
By default, packets conforming to neither CIR nor PIR are dropped.
yellow action: Specifies the action to be conducted for the traffic conforms to PIR but
does not conform to CIR. The action argument can be:
z discard: Drops the packets.
z pass: Forwards the packets.
z remark-dscp-pass new-dscp: Marks the packets with a new DSCP precedence
and forwards them to their destinations. The new-dscp argument is in the range 0
to 63.
By default, packets conforming to PIR but not conforming to CIR are dropped.

Table of Contents

Other manuals for H3C S7500E Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S7500E Series and is the answer not in the manual?

H3C S7500E Series Specifications

General IconGeneral
BrandH3C
ModelS7500E Series
CategorySwitch
LanguageEnglish

Related product manuals