Command Manual – File System Management
H3C S7500E Series Ethernet Switches Chapter 2 FTP Configuration Commands
2-20
Parameters
server-address: IP address or host name of the remote FTP server.
service-port: Port number of the remote FTP server, in the range 0 to 65535. The
default value is 21.
-i interface-type interface-number: Specifies the egress interface by it type and number.
This parameter can be used only in case that the FTP server address is the link local
address and the specified egress interface must have a link local address (For the
configuration of link local address, see IPv6 Configuration.).
Description
Use the open ipv6 command to log onto IPv6 FTP server in FTP client view.
At login, you will be asked to enter the username and password for accessing the FTP
server. If your input is correct, the login succeeds; otherwise, it fails.
Related commands: close.
Examples
# Log onto the FTP server (with IPv6 address 3000::200) in FTP client view.
<Sysname> ftp
[ftp] open ipv6 3000::200
Trying 3000::200 ...
Press CTRL+K to abort
Connected to 3000::200.
220 Welcome!
User(3000::200:(none)): MY_NAME
331 Please specify the password.
Password:
230 Login successful.
2.2.21 passive
Syntax
passive
undo passive
View
FTP client view
Parameters
None
To Next Page
Loading...
Need help?
General
