H3C S7500E Series

Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-13
Examples
# Set the timeout time of AUX 0 to 1 minute.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] idle-timeout 1 0
1.1.13 lock
Syntax
lock
View
User view
Parameters
None
Description
Use the lock command to lock the current user interface to prevent unauthorized users
from operating the user interface.
With the execution of this command, the system prompts to enter and confirm the
password (up to 16 characters), and then locks the user interface.
To cancel the lock, press the Enter key and enter the correct password.
By default, the system will not lock the current user interface automatically.
Examples
# Lock the current user interface.
<Sysname> lock
Please input password<1 to 16> to lock current user terminal interface:
Password:
Again:
locked !
# Cancel the lock.
Password:
<Sysname>