Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-9
Table 2-4 Description on the fields of the display rip route command
Field Description
Route Flags
R — RIP route
T — TRIP route
P — The route never expires
A — The route is aging
S — The route is suppressed
G — The route is in Garbage-collect state
Peer 21.0.0.23 on
Vlan-interface1
Routing information learned on a RIP interface from the
specified neighbor
Destination/Mask Destination IP address and subnet mask
Nexthop Next hop of the route
Cost Cost of the route
Tag Route tag
Flags Indicates the route state
Sec Remaining time of the timer corresponding to the route state
# Display the routing statistics of RIP process 1.
<Sysname> display rip 1 route statistics
Peer Aging Permanent Garbage
21.0.0.23 2 0 3
21.0.0.12 2 0 4
Total 4 0 7
Table 2-5 Description on the fields of the display rip route statistics command
Field Description
Peer IP address of a neighbor
Aging Total number of aging routes learned from the specified neighbor
Permanent
Total number of permanent routes learned from the specified
neighbor
Garbage
Total number of routes in the garbage-collection state learned
from the specified neighbor
Total Total number of routes learned from all RIP neighbors
To Next Page
Loading...
Need help?
General
