Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-11
# Reference IP prefix list abc to filter outbound routes on VLAN-interface 10.
[Sysname-rip-1] filter-policy ip-prefix abc export vlan-interface 10
2.1.9 filter-policy import
Syntax
filter-policy { acl-number | gateway ip-prefix-name | ip-prefix ip-prefix-name
[ gateway ip-prefix-name ] } import [ interface-type interface-number ]
undo filter-policy import [ interface-type interface-number ]
View
RIP view
Parameters
acl-number: Number of the Access Control List (ACL) used for filtering incoming routes,
in the range of 2000 to 3999.
ip-prefix ip-prefix-name: References an IP prefix list to filter incoming routes. The
ip-prefix-name is a string of 1 to 19 characters.
gateway ip-prefix-name: References an IP prefix list to filter routes from the gateway.
interface-type interface-number: Specifies an interface.
Description
Use the filter-policy import command to filter the incoming routes.
Use the undo filter-policy import command to restore the default.
By default, RIP does not filter incoming routes.
Related commands: acl and ip ip-prefix.
Examples
# Reference ACL 2000 to filter incoming routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] filter-policy 2000 import
# Reference IP prefix list abc on VLAN-interface 10 to filter all received RIP routes.
[Sysname-rip-1] filter-policy ip-prefix abc import vlan-interface 10
2.1.10 host-route
Syntax
host-route
To Next Page
Loading...
