H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-17
View
User view
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the reset rip statistics command to clear the statistics of the specified RIP
process.
Examples
# Clear statistics in RIP process 100.
<Sysname> reset rip 100 statistics
2.1.17 rip
Syntax
rip [ process-id ]
undo rip [ process-id ]
View
System view
Parameters
process-id: RIP process ID, in the range of 1 to 65535. The default is 1.
Description
Use the rip command to create a RIP process and enter RIP view.
Use the undo rip command to disable a RIP process.
By default, no RIP process runs.
Note that:
z You must enable the RIP process before configuring the global parameters. This
limitation is not for configuration of interface parameters.
z The configured interface parameters become invalid after you disable the RIP
process.
Examples
# Create a RIP process and enter RIP process view.
<Sysname> system-view
[Sysname] rip

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English