H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 2 RIP Configuration Commands
2-28
Examples
# Specifies the update, timeout, suppress, and garbage-collect timers as 5, 15, 15 and
30 respectively.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] timers update 5
[Sysname-rip-100] timers timeout 15
[Sysname-rip-100] timers suppress 15
[Sysname-rip-100] timers garbage-collect 30
2.1.31 validate-source-address
Syntax
validate-source-address
undo validate-source-address
View
RIP view
Parameters
None
Description
Use the validate-source-address command to enable the source IP address
validation on incoming RIP routing updates.
Use the undo validate-source-address command to disable the source IP address
validation.
The source IP address validation is enabled by default.
Generally, disabling the validation is not recommended.
Examples
# Enable the source IP address validation on incoming messages.
<Sysname> system-view
[Sysname-rip] rip 100
[Sysname-rip-100] validate-source-address
2.1.32 version
Syntax
version { 1 | 2 }