H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-11
Parameters
None
Description
Use the default ipv4-unicast command to enable the use of IPv4 unicast address
family for all peers.
Use the undo default ipv4-unicast command to disable the use of IPv4 unicast
address family for all peers.
The use of IPv4 unicast address family is enabled by default.
Examples
# Enable IPv4 unicast address family for all neighbors.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default ipv4-unicast
5.1.13 default local-preference
Syntax
default local-preference value
undo default local-preference
View
BGP view
Parameters
value: Default local preference, in the range 0 to 4294967295. The larger the value is,
the higher the preference is.
Description
Use the default local-preference command to configure the default local preference.
Use the undo default local-preference command to restore the default value.
By default, the default local preference is 100.
Using this command can affect BGP route selection.
Examples
# In BGP view, set the default local preference to 180.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] default local-preference 180

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English