H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-30
Description
Use the display bgp routing-table statistic command to display BGP routing
statistics.
Examples
# Display BGP routing statistics.
<Sysname> display bgp routing-table statistic
Total Number of Routes: 4
Table 5-10 Description on the fields of the display bgp routing-table statistic
command
Field Description
Total number of routes Total number of routes
5.1.32 ebgp-interface-sensitive
Syntax
ebgp-interface-sensitive
undo ebgp-interface-sensitive
View
BGP view
Parameters
None
Description
Use the ebgp-interface-sensitive command to enable the clearing of EBGP session
on any interface that becomes down.
Use the undo ebgp-interface-sensitive command to disable the function.
This function is enabled by default.
Examples
# In BGP view, enable the clearing of EBGP session on any interface that becomes
down.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ebgp-interface-sensitive