H3C S7500E Series

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches Chapter 5 BGP Configuration Commands
5-36
5.1.39 peer advertise-community
Syntax
peer { group-name | ip-address } advertise-community
undo peer { group-name | ip-address } advertise-community
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
Description
Use the peer advertise-community command to advertise the community attribute to
a peer/peer group.
Use the undo peer advertise-community command to disable the community
attribute advertisement to a peer/peer group.
By default, no community attribute is advertised to any peer group/peer.
Related commands: ip community-list, if-match community, apply community.
Examples
# In BGP view, advertise the community attribute to peer group test.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test advertise-community
5.1.40 peer advertise-ext-community
Syntax
peer { group-name | ip-address } advertise-ext-community
undo peer { group-name | ip-address } advertise-ext-community
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.