H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-2
5.1.2 bestroute as-path-neglect
Syntax
bestroute as-path-neglect
undo bestroute as-path-neglect
View
IPv6 address family view
Parameters
None
Description
Use the bestroute as-path-neglect command to configure the IPv6 BGP router to not
evaluate the AS_PATH during best route selection.
Use the undo bestroute as-path-neglect command to configure the IPv6 BGP router
to use the AS_PATH during best route selection.
By default, the router takes AS_PATH as a factor when selecting the best route.
Examples
# Ignore AS_PATH in route selection.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] bestroute as-path-neglect
5.1.3 bestroute compare-med
Syntax
bestroute compare-med
undo bestroute compare-med
View
IPv6 address family view
Parameters
None
Description
Use the bestroute compare-med command to enable the comparison of the MED for
paths from each AS.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English