H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-14
Table 5-5 Description on the fields of the display bgp ipv6 routing-table command
Field Description
Local router ID Local router ID
Status codes
Status codes:
* – valid
> – best
d – damped
h – history
i – internal (IGP)
s – summary suppressed (suppressed)
S – Stale
Origin
i – IGP (originated in the AS)
e – EGP (learned through EGP)
? – incomplete (learned by other means)
Network Destination network address
PrefixLen Prefix length
NextHop Next Hop
MED MULTI_EXIT_DISC attribute
LocPrf Local preference value
Path
AS_PATH attribute, recording the ASs the packet has passed to
avoid routing loops
PrefVal Preferred value
Label Label
Origin attribute of the route, which can take on one of the following
values:
i
Indicates that a route is interior to the AS.
Summary routes and the routes configured using the
network command are considered IGP routes.
e
Indicates that a route is learned from the exterior
gateway protocol (EGP).
Ogn
?
Short for INCOMPLETE. It indicates that the origin of a
route is unknown and the route is learned by other
means. BGP sets Origin attribute of routes learned from
other IGP protocols to INCOMPLETE.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English