Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-43
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
Description
Use the peer public-as-only command to configure IPv6 BGP updates to a peer/peer
group to not carry private AS numbers.
Use the undo peer public-as-only command to allow IPv6 BGP updates to a
peer/peer group to carry private AS numbers.
By default, BGP updates carry the private AS number.
The command does not take effect if the BGP update has both the public AS number
and private AS number. The range of private AS number is from 64512 to 65535.
Examples
# Carry no private AS number in BGP updates sent to the peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 public-as-only
5.1.51 peer reflect-client
Syntax
peer { ipv6-group-name | ipv6-address } reflect-client
undo peer { ipv6-group-name | ipv6-address } reflect-client
View
IPv6 address family view
Parameters
ipv6-group-name: Name of an IPv6 peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
Description
Use the peer reflect-client command to configure the router as a route reflector and
specify a peer/peer group as a client.
Use the undo peer reflect-client command to remove the configuration.
By default, neither route reflector nor client is configured.
Related commands: reflect between-clients, reflector cluster-id.
To Next Page
Loading...
Need help?
General
