H3C S7500E Series - Page 646

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches Chapter 5 IPv6 BGP Configuration Commands
5-46
5.1.54 peer route-update-interval
Syntax
peer { ipv6-group-name | ipv6-address } route-update-interval seconds
undo peer { ipv6-group-name | ipv6-address } route-update-interval
View
IPv6 address family view
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
seconds: Specifies the minimum interval for sending the same update to a peer (group)
from 5 to 600 seconds.
Description
Use the peer route-update-interval command to specify the interval for sending the
same update to a peer/peer group.
Use the undo peer route-update-interval command to restore the default.
By default, the interval is 15 seconds for the IBGP peer, and 30 seconds for the EBGP
peer.
Examples
# Specify the interval for sending the same update to the peer 1:2::3:4 as 10 seconds.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 as-number 100
[Sysname-bgp-af-ipv6] peer 1:2::3:4 route-update-interval 10
5.1.55 peer substitute-as
Syntax
peer { ipv6-group-name | ipv6-address } substitute-as
undo peer { ipv6-group-name | ipv6-address } substitute-as
View
IPv6 address family view