EasyManua.ls Logo

H3C S7500E Series

H3C S7500E Series
1565 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches
Chapter 3 MAC Authentication Configuration
Commands
3-3
Field Description
Authenticate state
User status. Possible values are:
z CONNECTING: The user is logging
in.
z SUCCESS: The user has passed the
authentication.
z FAILURE: The user failed the
authentication.
z LOGOFF: The user has logged off.
AuthIndex Authenticator Index
3.1.2 mac-authentication
Syntax
mac-authentication [ interface interface-list ]
undo mac-authentication [ interface interface-list ]
View
System view, Ethernet interface view
Parameters
interface interface-list: Specifies an Ethernet port list, in the format of { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
indicates that you can specify up to 10 port ranges. A port range defined without the to
interface-type interface-number portion comprises only one port.
Description
Use the mac-authentication command to enable MAC authentication globally or for
one or more ports.
Use the undo mac-authentication command to disable MAC authentication globally
or for one or more ports.
By default, MAC authentication is neither enabled globally nor enabled on any port.
Note that:
z In system view, if you provide the interface-list argument, the command enables
MAC authentication for the specified ports; otherwise, the command enables MAC
authentication globally. In Ethernet interface view, the command enables MAC
authentication for the port without requiring the interface-list argument.
z You can configure MAC authentication parameters globally or for specified ports
either before or after enabling MAC authentication. If no MAC authentication

Table of Contents

Other manuals for H3C S7500E Series

Related product manuals