H3C S7500E Series

Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-3
Field Description
service-dot1p
8021p-list
Specifies to match packets by 802.1p precedence of the
service provider network. The 8021p-list argument is a list
of CoS values. You can provide up to eight
space-separated CoS values for this argument. CoS is in
the range 0 to 7.
source-mac
mac-address
Specifies to match the packets with a specified source
MAC address.
customer-vlan-id
vlan-id-list
Specifies to match the packets of specified VLANs of user
networks. The vlan-id-list argument specifies a list of
VLAN IDs, in the form of vlan-id to vlan-id or multiple
discontinuous VLAN IDs (separated by space). You can
specify up to eight VLAN IDs for this argument at a time.
VLAN ID is in the range 1 to 4094.
In a class configured with the operator and, the logical
relationship between the customer VLAN IDs specified for
the customer-vlan-id keyword is or.
service-vlan-id
vlan-id-list
Specifies to match the packets of specified VLANs of the
operator’s network. The vlan-id-list argument is a list of
VLAN IDs, in the form of vlan-id to vlan-id or multiple
discontinuous VLAN IDs (separated by space). You can
specify up to eight VLAN IDs for this argument at a time.
VLAN ID is in the range 1 to 4094.
In a class configured with the operator and, the logical
relationship between the service VLAN IDs specified for
the service-vlan-id keyword is or.
Description
Use the if-match command to define a rule to match a specific type of packets.
Use the undo if-match command to remove a matching rule.
 Note:
Suppose the logical relationship between classification rules is and. Note the following
when using the if-match command to define matching rules.
z If multiple matching rules with the acl or acl ipv6 keyword specified are defined in a
class, the actual logical relationship between these rules is or when the policy is
applied.
z If multiple matching rules with the customer-vlan-id or service-vlan-id keyword
specified are defined in a class, the actual logical relationship between these rules is
or when the policy is applied.