H3C S7500E Series

Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-4
Examples
# Define a rule for class1 to match the packets with their destination MAC addresses
being 0050-ba27-bed3.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match destination-mac 0050-ba27-bed3
# Define a rule for class2 to match the packets with their source MAC addresses being
0050-ba27-bed2.
<Sysname> system-view
[Sysname] traffic classifier class2
[Sysname-classifier-class2] if-match source-mac 0050-ba27-bed2
# Define a rule for class1 to match the advanced IPv4 ACL 3101.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match acl 3101
# Define a rule for class1 to match the advanced IPv6 ACL 3101.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match acl ipv6 3101
# Define a rule for class1 to match all the packets.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match any
# Define a rule for class1 to match the packets with their DSCP precedence values
being 1.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match dscp 1
# Define a rule for class1 to match the packets with their IP precedence values being 1.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match ip-precedence 1
# Define a rule for class 1 to match IP packets.
<Sysname> system-view
[Sysname] traffic classifier class1
[Sysname-classifier-class1] if-match protocol ip
# Define a rule for class 1 to match the packets with the customer network 802.1p
precedence 2.