Command Manual – QoS
H3C S7500E Series Ethernet Switches Chapter 2 QoS Policy Configuration Commands
2-24
Accounting Enable:
0 (Packets)
Committed Access Rate:
CIR 6400 (kbps), CBS 4000 (byte), EBS 4000 (byte)
Green Action: pass
Red Action: discard
Yellow Action: pass
Green : 0(Packets)
Table 2-9 Description on the fields of the display qos vlan-policy command
Field Description
Vlan 300 ID of the VLAN where the VLAN policy is applied
Inbound VLAN policy is applied in the inbound direction of the VLAN.
Classifier Name of the class in the policy and its configuration
Behavior Name of the behavior in the policy and its configuration
2.3.6 qos apply policy
Syntax
qos apply policy policy-name { inbound | outbound }
undo qos apply policy { inbound | outbound }
View
Ethernet port view, port group view
Parameters
inbound: Specifies the inbound direction.
outbound: Specifies the outbound direction.
policy-name: Specifies the policy name.
Description
Use the qos apply policy command to apply a policy on a port or a port group.
Use the undo qos apply policy command to remove the policy applied on a port or a
port group.
Note that, when you apply a policy by using the qos apply policy command, whether
or not the inbound/outbound keyword can take effect depends on the actions defined
in the traffic behavior and LPU types, as described in
Table 2-10.
To Next Page
Loading...
Need help?
General
